READY — TAP A PAD200 SOUNDS
92 BPMPAD 1
Streams on demand
Easy mode: Tap pads to hear sounds. Press LIVE RECORD, then tap the pads while the beat loops.
Your taps are added to the 16-step pattern automatically.
MAKE A SONG
1
Record your finished beat
2
Add your vocals over that beat
3
Listen or save it
BEAT TAKE: EMPTYVOCAL MIX: EMPTY
1. TAP THE PADS
Tap the big part of a pad to hear it. Tap the orange ▼ button on its right to change that pad’s sound.
Volume / mute each pad
2. BUILD THE LOOP
Live Record: press it, then tap drum pads. Each hit snaps to the nearest step so your loop stays on beat.
3. HUM A TUNE → TURN IT INTO AN INSTRUMENT
Pick an instrument, press HUM INTO LOOP, then hum the melody.
Beat Lab follows your pitch and puts the notes into the same 16-step loop.
Headphones work best so the phone speaker does not leak into the microphone.
MIC PERMISSION: checking…
HEARING—
PLAYING ASAcoustic Guitar
MICOFF
YOUR 16-STEP TUNE
Instrument notes are real pre-rendered FluidR3_GM SoundFont samples, not oscillator stand-ins.
FluidR3_GM is released under Creative Commons Attribution 3.0.
Soundfont source / attribution.
4. Full sample library / advanced — 200 sounds
SAMPLE LIBRARY
Sample rights used by this build:
Michael Fischer's 116 TR-808 recordings are CC0 1.0 and were recorded directly from a real TR-808 at 16-bit / 44.1 kHz.
The additional classic-machine samples come from the 0x808 sample library; its bundled TR-808/TR-909/TR-505 material is listed as no-attribution-required,
while the LinnDrum LM-2 and CR-78 folders are listed as public domain.
Source documentation: Michael Fischer TR-808 source · 0x808 sample license.
Source documentation: Michael Fischer TR-808 source · 0x808 sample license.